Lamp (Re)Placement - LIGHTSIDE Mirror Ball SET20 Manual De Usuario

SET 20
ENGLISH
• Allow the device about 10 minutes to cool down before replacing the bulb or start
servicing.
• Always unplug the unit when it is not used for a longer time or before replacing the
bulb or start servicing.
• The electrical installation should be carried out by qualified personal only, according to
the regulations for electrical and mechanical safety in your country.
• Check that the available voltage is not higher than the one stated on the rear panel of
the unit.
• The power cord should always be in perfect condition: switch the unit immediately off
when the power cord is squashed or damaged.
• Never let the power-cord come into contact with other cables!
• This fixture must be earthed to in order comply with safety regulations.
• Don't connect the unit to any dimmer pack.
• Always use an appropriate and certified safety cable when installing the unit.
• In order to prevent electric shock, do not open the cover. Apart from the lamp and
mains fuse there are no user serviceable parts inside.
• Never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a
fuse of the same type and electrical specifications!
• In the event of serious operating problems, stop using the fixture and contact your
dealer immediately.
• The housing and the lenses must be replaced if they are visibly damaged.
• Please use the original packing when the device is to be transported.
• Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
IMPORTANT! Never look directly into the light source! Don't use the effect in the
presence of persons su ering from epilepsy.

LAMP (RE)PLACEMENT

In case of replacement of the lamp or maintenance, do not open the fixture within 10
minutes until the unit cools down after switching o . Always unplug the unit before
servicing! Always use the same type of spare parts (bulbs, fuses, etc.) When
replacing parts, please only genuine spare parts.
• Switch off the projector and unplug the mains cable.
• Wait for about 10 minutes until the projector has been cooled down.
• Remove the fixation ring in front of the lamp by pressing it together.
• Remove the old lamp from the projector and unscrew the wires to the lamp.
• Loosen the screws on the new 6V 30W Par 36 lamp.
• Connect the wires with the new lamp
• Tighten the screws using an appropriate screwdriver
2