Setting The Auto-Start / Timer; Singlecup Function - CASO DESIGN Aroma Sense Manual Del Usuario

8.
After approx. 6 minutes, the brewing process is complete and the machine automati-
cally switches to "keep-warm mode". Then the warming plate is heated for another 40
minutes to keep the coff ee at a temperature of 80 – 85 °C.
9.
After this, the machine automatically switches to standby mode and ON/OFF lights
up in the display.
PLEASE NOTE

If there is no water in the water tank when the brewing process starts, the ON/OFF
button fl ashes and the machine does not start.

The machine can also be operated with other matching fi lter bags in the 1x4 size.

Important: During the brewing process, the fl avour regulator must be set to a posi-
tion between 0.25 and 1.25 so that the water fl ows through. If the fl avour regulator
is set to the "Drip stop" position for too long (longer than 30 sec.) or if a too low drip
speed is selected, the fi lter holder fi lls with water fi rst. The water then fl ows out at
the overfl ow opening causing ground coff ee to get into your coff ee.

Switch off the machine when you have taken the last coff ee out of the pot. Do not
place the empty pot on the hot warming plate.

5.4 Setting the AUTO-Start / Timer

You can set the machine to start the brewing process automatically at a desired time.
To do this, the current time must be set beforehand, and the preparations for making
coff ee should be completed.
1.
Press the "AUTO" button.
2.
The word "TIMER" fl ashes 5 times in the display.
3.
Set the desired timer time with the "HOUR" and the "MIN" buttons.
4. Confi rm the timer time by pressing the AUTO button again or by pressing the ON/
OFF button.
5.
The "AUTO" button lights up red and the display shows the current time again after
approx. 5 seconds.
6. You can check the timer time again by pressing the "AUTO" button again for 3 se-
conds. The timer time is then displayed for about 5 seconds and then the current time
is displayed again automatically.
7.
As soon as the set time is reached, the brewing process starts automatically.
PLEASE NOTE

You can cancel the set timer by pressing the AUTO button again. If the timer function
has been deactivated, the "AUTO" button lights up white again.

5.5 SingleCup function

You can also place other containers under the fi lter holder insert. Only use vessels that are
heat-resistant and large enough to hold all the water in the water tank. In addition, the top
opening must be large enough so the coff ee does not drip beside it. Place the container
exactly under the centre of the fi lter holder and supervise the brewing process. Ensure
that the coff ee drips evenly into the container and does not run down the edge.
CASO Aroma Sense
DE
EN
FR
IT
ES
NL
RUS
PT
31