Operating Tips; Turning The Laser On - DeWalt DCLE34220 Manual De Instrucciones

Viewing the Battery Meter
When the laser is ON, the battery meter on the keypad
(Figure
C 9
Each of the four LEDs on the battery meter represents
25% of the power.
• The bottom LED will illuminate and flash when the
battery level is low (below 12.5%). The laser may
continue to operate for a short time while the battery
power continues to drain, but the beam(s) will
quickly dim.
• After the 12V/20V MAX Li-ion battery is charged, and
the laser is turned ON again, the laser beam(s) will
return to full brightness and the battery indicator level
will indicate full capacity.
• If all 4 LEDs on the battery meter remain ON, this
indicates that the laser is not fully powered OFF.
When the laser is not in use, make sure the Power/
Transport Lock switch is placed to the LEFT to the
Locked/OFF position (Figure

Operating Tips

• To extend battery life per charge, turn the laser off
when it is not in use.
• To ensure the accuracy of your work, check
the laser calibration often. Refer to Checking
Laser Accuracy.
• Before attempting to use the laser, make sure it is
es
positioned securely, on a smooth, flat stable surface
A
that is level in both directions.
• To increase beam visibility, use a Laser Target Card
(Figure
(Figure
CAUTION:
never stare directly into the laser beam with or
without these glasses. Refer to Accessories for
important information.
2
1b
) indicates how much power remains.
).
C 2
x1
3
Figures
) and/or wear Laser Enhancement Glass es
O
) to help find the beam.
P
Figures
A
x2
To reduce the risk of serious injury,
x3
1
1a
• Always mark the center of the beam created by
the laser.
• Extreme temperature changes can cause movement
or shifting of building structures, metal tripods,
equipment, etc., which can effect accuracy. Check
your accuracy often while working.
• If the laser has been dropped, check to make sure
your laser is still calibrated. Refer to Checking
Laser Accuracy.

Turning the Laser On

Place the laser on a flat level surface. Slide the Power/
Transport Lock switch
ON the laser.
Button
DCLE34220
DCLE34520
3a
x1
You can use
A
dots and lines. For example, if you press
3
times and
and two dots (Figure x1 3a
3
3b
x2
3b
x2
2
1
1a
1b
3c
x3
3c
2
1b
B
3f
to the right to unlock/turn
C 2
Displays
• Press once to display a horizontal laser
line (Figure ).
C 4
• Press a second time to display a
vertical laser line (Figure
• Press a third time to display a
horizontal line and a vertical line
(Figure ).
C 6
• Press a fourth time to stop displaying
laser lines.
• Press once to display dots above and
below the laser (Figure
• Press a second time to stop
displaying dots.
3d
and / together to display laser
3d
x1 3a x1
/ once, the laser will display cross lines
3d
x1 ).
C 8
3e 3b
x2 3e
x2
3e
x2
x3 3c
x3 x2
3f
x2
x3
C
1/4-20
E
).
C 5
).
C 7
three
17