Service And Repair; Optional Equipment; Jaws; Battery Pack - RIDGID RP 115 Manual Del Operador

RP 115 Press Tool
Troubleshooting
PROBLEM
Excessively large or
sharp fins present at
press joint parting line
where jaw tips come
together.
Jaws stick to fitting
excessively after com-
pleting press joint.
Oil leaks from tool.
Motor runs but tool
will not complete a
cycle.
Tool stops during
operation.
See Figure 5 for Tool Status Lights.

Service And Repair

WARNING
Improper service or repair can make
machine unsafe to operate.
Service and repair on the RP 115 Press Tool
must be performed by a RIDGID Authorized
Independent Press Tool Service Center.
For information on your nearest RIDGID
Authorized Independent Press Tool Service
Center or any service or repair questions see
Contact Information section in this manual.

Optional Equipment

WARNING
To reduce the risk of injury, only use
equipment specifically designed and
recommended for use with the RP 115
Press Tool, such as listed below.
Catalog
No. Description
75338 Carry Case, RP 115
12
(Cont.)
POSSIBLE REASON
Fitting material build up in the con-
toured profile area near jaw tips.
Excessively worn or damaged jaws.
Fitting material build up in the con-
toured profile area near jaw tips.
Seal or mechanical problems.
Oil level low
Oil level low
.
Clean jaw in the contoured area using
metal polishing pads such as Scotch-
Brite . Refer to Maintenance Section
®
for instructions.
Discard jaws and replace with new
RIDGID jaw set.
Clean jaw in the contoured area using
metal polishing pads such as Scotch-
Brite . Refer to Maintenance Section
®
for instructions.
See Contact Information for near-
est RIDGID Authorized Independent
Service center.

Jaws

Catalog
No. Description
72563 ½" Mini PureFlow Jaw
72568 ¾" Mini PureFlow Jaw
72578 ½" Mini ProPress Jaw
72583 ¾" Mini ProPress Jaw

Battery Pack

Catalog
No. Description
55183 RB-1225R
Battery will work with any catalog number
RBC-121 Battery Charger.
SOLUTION
Weight
2.2 lbs. (1 kg)
2.2 lbs. (1 kg)
2.2 lbs. (1 kg)
2.2 lbs. (1 kg)
Capacity
10.8V (2.5Ah)
999-995-408.10_REV. A