Troubleshooting - Klarstein 10041143 Manual De Instrucciones

EN
30
Important notes on operation
• Make sure that the water tank, water filter and water separation pipe are not
blocked. Clean them.
• The water temperature influences the ice cube production. The lower the
water temperature, the more ice cubes are produced.
• The lower the ambient temperature, the more ice cubes are produced.
• Only use good quality water to ensure that the pump works properly. If you
use poor quality water, this may cause the pump to be noisy. However, this
has no effect on the operation of the pump.
• When you switch off the unit, the compressor will start 3 minutes later.

TROUBLESHOOTING

Problem Potential cause
No water
The symbol
lights up
Too many ice cubes in the
The symbol
ice basket
lights up
The inlet solenoid valve is
The water tank
is full but the broken
symbol lights
up
The symbol [E1] The room temperature
lights up sensor is broken.
The symbol [E2] The water temperature
lights up sensor is broken.
Possible solution
Switch off the device and fill
the water tank with drinking
water up to the maximum
mark. Restart the unit.
Remove the ice cubes from
the ice basket
Contact customer service
The unit is still functional,
replace the sensor
The unit is still functional,
replace the sensor