Before Use; During Use; Before First Use; Intended Use - Batavia FIXXPACK 12 V BT-CCD003 Manual De Usuario

• Battery chargers are for indoors use
only. Ensure that the power supply and
charger are protected against moisture
at all times.
• Ensure that the lighting is adequate.
• Ensure that the drill bit is securely fixed
in the chuck. Insecure drill bits can be
ejected from the machine causing a
hazard.
• Ensure that the drill bit is not in contact
with the workpiece prior to starting up
the tool.
• Before drilling, check that there is suffi-
cient clearance for the drill bit under the
workpiece.
• Drill bits get hot during operation, allow
to cool prior to handling them.
• NEVER use your hands to remove saw-
dust, chips or waste close by the bit.
• Examine the chuck regularly for signs of
wear or damage. Have damaged parts
repaired by a qualified service centre.
• ALWAYS wait until the drill has come to
a complete stop before putting it down.

3. Before use

• Avoid damage that can be caused by
screws, nails and other elements in your
workpiece; remove them before you
start working.
• Use suitable detectors to find hidden
utility lines or call the local utility com-
pany for assistance (contact with elec-
tric lines can lead to fire or electrical
shock; damaging a gas line can result in
an explosion; penetrating a water pipe
will cause property damage or an elec-
trical shock).
• Secure the workpiece (a workpiece
clamped with clamping devices or in a
vice is held more securely than by
hand).

4. During use

• Hold power tool by insulated gripping
surfaces (8), when performing an oper-
ation where the cutting accessory or
fastener may contact hidden wiring
(cutting accessory and fasteners con-
tacting a "live" wire may make exposed
7064214-Cordless_Combi_Drill-Ma-2203-08.indb 7 7064214-Cordless_Combi_Drill-Ma-2203-08.indb 7
metal parts of the power tool "live" and
could give the operator an electric
shock).
• In case of electrical or mechanical mal-
function, immediately switch off the
tool or unplug charger from power
source.

5. Before first use

Remove the machine and the accessories
from the packaging. Check the machine for
transport damage and do not use the
machine in case of damages. Keep the
packing materials away from children, risk
of suffocation!

6. Intended use

The cordless hammer drill/screwdriver is
designed for tightening and undoing screws,
for drilling in wood, metal and plastic, and
for hammer drilling in stone, in each case
when using the appropriate bits. The equip-
ment is to be used only for its prescribed
purpose.

7. Operation

Direction control
7.1
• The direction of rotation can be set
using the Forward/Reverse Switch (7).
• For anti-clockwise rotation, push the
switch to the right.
• For clockwise rotation, push the switch
to the left.
Note: When the Forward/Reverse Switch is
in the central position, the drill is locked and
cannot be switched on. Use this setting as a
safety feature to prevent the drill from being
switched on accidentally.

Mode selector

7.2
The clutch settings are indicated by the
symbols on the Mode Selector (4).
Torque Selector
7.3
Rotate the Torque Selector (3) to select the
desired setting: the higher the number dis-
played on the torque ring, the higher the
torque produced by the tool.

Speed setting

7.4
The machine has 2 drill speeds, which can
be adjusted by sliding the gear switch (5)
forward or backwards. The number on the
English
7
10-03-2022 11:54 10-03-2022 11:54