Troubleshooting - cecotec bolero COOLMARKET COMBI 495 INOX Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
ENGLISH
cleaners, or organic solvents such as benzene for cleaning. They could damage the surface
of the refrigerator and cause a fire.
Interior cleaning
-
You must clean the interior of the refrigerator periodically.
-
Clean the interior of the refrigerator with a weak solution of baking soda and then rinse it
with warm water using a wrung-out cloth or sponge. Dry it completely before replacing
the shelves and the drawers. Dry all the surfaces and the detachable parts thoroughly
before placing them back in place. Fig. 33
Defrost
Even if the refrigerator has an automatic defrost function, there could be a layer of frost in the
interior of the freezer compartment if the door has been frequently opened or if it remained
open for a long period of time. If the frost is too thick, follow these steps:
1.
Remove the food and the drawers, unplug the refrigerator from the mains, and leave
the doors open. Ventilate the room well to speed up the defrosting process.
2.
After it has been completely defrosted, clean the freezer compartment following the
process described.
Warning
Do not use sharp objects to remove frost. You should only plug and turn on the refrigerator
when the interior is completely dry.
Cleaning the door gasket
Try to keep the doors' gasket clean. Sticky food and drinks can cause the gaskets to stick to the
structure of the refrigerator and break when the door is opened. Wash the gasket with a soft
detergent and warm water. Rinse it and dry it thoroughly after cleaning it.
Warning
You must only turn the refrigerator on after the door gaskets are completely dry.
Substitution of the LED light
Warning:
The LED light can only be substituted by authorised personnel. If the LED light is damaged,
contact the official Customer Service of Cecotec for assistance.
To replace the LED light, follow these steps:
1.
Unplug the refrigerator.
2.
Remove the light cover by pressing it upwards and outwards.
3.
Hold the LED light cover with a hand and pull with the other while you press the
connector.
4.
Substitute the LED light and place it correctly in place.
74

8. TROUBLESHOOTING

If you experience any problem with the refrigerator or think it does not work properly, you can
carry out a few simple checks before calling the official Cecotec Customer Service.
Warning
Do not try to repair the refrigerator on your own. If the problem persists after the checks
explained below, contact a qualified electrician, authorised personnel, or the store where you
purchased the product.
Problem
The refrigerator does not work properly
Smells inside the compartments
The refrigerator makes some noise
ENGLISH
Possible cause and solution
Check if the electrical cord is plugged in
correctly to the mains supply.
Check the fuse or the power supply circuit and
replace them if necessary.
The room temperature is out of the range for
which the refrigerator was manufactured.
Place the refrigerator in a room where the
temperature is within the allowed range.
It is normal for the freezer compartment not
to operate during the automatic defrost cycle,
or for a short time after the refrigerator is
switched on to protect the compressor.
You may need to clean the interior.
Some food, containers, or packaging may
release smells.
The noises described next are common:
Compressor operation noise.
-
Air flow noise of the small fan motor
-
in the freezer compartment or other
compartments.
Dripping sound similar to boiling water.
-
Knocking sound during automatic
-
defrosting.
Clicking sound before the compressor
-
starts.
Other unusual noises may be caused by the
situations described next and you may need
to check them and take action:
-
The refrigerator is not levelled.
-
The rear part of the refrigerator is in
contact with the wall.
-
The bottles or containers hit each other.
75
COOLMARKET COMBI 495 INOX

Publicidad

Tabla de contenido
loading

Tabla de contenido