Maintenance - Dexter 800ETC1 Manual De Instrucciones

• Ensure that the guard is correctly mounted.
• Ensure that no one other than the operator is in the working area.
FR
• For safety reasons replace the tool if it is found to be damaged in any way.
• To switch on, press the "1" on the On/Off switch.
• Before you begin cutting, wait until the cutting wheel has reached maximum speed and the cooling
ES
water pump has started supplying water to the cutting wheel.
• To switch off, press the "0" on the On/Off switch.
PT
MAKING 90° CUTS
• Loosen the handle screw and push the angle stop into the required position. Set the angle to 0°
degrees, then tighten the handle screw again in order to secure the angle stop.
IT
• Then loosen the clamping screw and push it to the required position.
• Now move the machine head to the rear using the handle.
• Place a tile against the stop rail and the angle stop.
EL
• Switch on the machine.
• Important: Wait until the cooling water has reached the cutting wheel.
• Using the handle, move the machine head forward slowly and smoothly through the tile.
PL
MAKING 45° DIAGONAL CUTS
UA
• Set the angle stop to 45°.
• Make the cut.
MAKING 45° LONGITUDINAL CUTS ("JOLLY CUTS")
RO
• Loosen the clamping screw.
• Tilt the guide rail to the left to 45° on the angle scale.
• Retighten the clamping screw.
EN
• Make the cut.
CHANGING THE DIAMOND CUTTING WHEEL
• Pull out the power plug!
• Loosen and remove the clamping screw for the cutting wheel guard.
• Swing up the guard.
• Place the wrench on the motor shaft and hold.
Left-hand thread.)
• Install the new cutting wheel in reverse order and tighten.
• Important: Pay attention to the direction of rotation of the cutting wheel!

8. MAINTENANCE

Cleaning and maintenance overview
Prior to every start
What
Check mains cable, mains plug, supply cables,
cold water pump And cutting wheel for damage
WARNING ! Remove the plug from the power socket before
carrying out any adjustment, servicing or maintenance.
tation of the cutting wheel. (Caution:
cutting wheel.
How?
Visual inspection.
123