Changing The Dust Bag; Cleaning The Foam Filter - Maxvac DV20-MB Instrucciones De Uso Y Mantenimiento

USING THE DUST BAG
Use the dust bag only
when the filter cartridge is
installed. To pick up dust of
class 'M' the dust bag must
be installed in the appliance.
Insert the paper filter bag in the waste
drum.
Fit the plastic flange (X) into the air inlet
connector (Y). Be careful not to damage
the bag.
Use the bag to remove dirt more
hygienically.

CHANGING THE DUST BAG

Dispose of the bag in compliance with the special waste disposal
regulations in force in your country
The paper bag must never be re-used but only be replaced.
Remove the plastic flange (1) from the air inlet connector (2).Take out the full bag.
Close the plastic flange with the cap provided.
1
2
18 DV 20 | 35 | 50 MB
X
Y
MAX-VAC.COM
FOR USE AS A WET VACUUM
Always remove the filter
cartridge and the paper filter
bag, if fitted. Use the foam
filter. The foam filter is not
suitable for vacuuming Class
'M' dust.
When the vacuumed liquids reach the
maximum level inside the drum, suction is
automatically cut off by the safety float. The
user is alerted by an increase in the RPM
rate of the motor and the lack of suction.
Turn off the appliance immediately and
empty the drum.
VACUUMING LARGE
QUANTITIES OF LIQUID
To ensure partial airflow, make sure
that the crevice tool is never fully
submerged.
CLEANING THE FOAM
FILTER
Rinse the foam filter with
water. DO NOT use detergent.
Replace if worn or torn.
DV 20 | 35 | 50 MB
MAX-VAC.COM 19