Troubleshooting; Eu Declaration Of Conformity - Maxvac DV20-MB Instrucciones De Uso Y Mantenimiento

TROUBLESHOOTING

Problems Causes
The appliance will No power
not start
Defective power cord,
switches or motor.
Reduced Drum too full
Efficiency
Filter cartridge is dirty
or caked.
Clogged tube or
accessories.
The RPM rate of the Drum too full.
motor is noticeably
higher. Filter cartridge is dirty
or caked.
Clogged tube or
accessories.
The appliance will not Defective circuit board.
start in "power tool"
mode.
28 DV 20 | 35 | 50 MB
Solutions
Check that the power
socket is working
Contact your technical
service centre (see
attached list).
Empty Drum
Thoroughly clean or
change the filter,
Check the hose or
accessories.
Check the drum.
Thoroughly clean or
change the filter,
Check the hose or
accessories.
Contact your technical
service centre (see
attached list).
MAX-VAC.COM
Do not dispose of electrical appliances with
household waste!
In compliance with European Directive 2012/19/EU on waste electrical and
electronic equipment (WEEE) and its implementation in accordance with
national law, electric tools that have reached the end of their lifecycle must be
collected separately and returned to an environmentally compatible recycling
facility.
"EC" DECLARATION OF
CONFORMITY"
The manufacturer declares that the products described in
these instructions
MV DV20 MB | MV DV35 MB | MV DV50 MB
Comply with the essential requisites of European Directives:
2014/35 / EU 2014/30 EU
and is in accordance with standards
EN 60335-1: 2012 + A11: 2014
EN 60335-2-69-2012
EN 62233: 2008
EN 55014-1: 2006 + A1: 2009 + A2: 2011
EN 55014-2: 2015
EN 61000-3-2: 2014
EN 61000-3-3: 2014
This declaration was drawn up in October 2016.
DV 20 | 35 | 50 MB
2011/65 / EU
MAX-VAC.COM 29