Warnings - Maxvac DV20-MB Instrucciones De Uso Y Mantenimiento

The appliance should be decontaminated by vacuum cleaning methods and
wiped clean or treated with sealant before being taken out of a hazardous area.
All the other appliance parts shall be regarded as contaminated when removed
from hazardous area and appropriate action taken to prevent dust dispersal.
During cleaning and maintenance, it is recommended to always wear personal
protection devices (gloves and mask) as required by the national regulations in
force.
Before proceeding with maintenance operations, it is strongly recommended to
first decontaminate the appliance by vacuuming clean air for a few minutes and
to clean it on the outside.
Maintenance and cleaning must be carried out in a room with adequate
ventilation and in such a way as not to endanger the operators or other persons.
Clean the place where maintenance is carried out in order to prevent that
hazardous substances are dispersed into the environment.
During maintenance, repair and disposal operations, all the contaminated parts
of the appliance that cannot be completely cleaned must be eliminated; put
them in impermeable bags according to the national regulations in force for
disposal of special waste.
For proper disposal, it is advisable to indicate on the impermeable bag which
substances have been vacuumed.
It is recommended to carry out a technical inspection on the appliance at least
once a year to check that the seals are tight and proper functioning of the
control mechanisms so that any malfunctions can be detected. Daily check the
integrity of the filter system.
8 DV 20 | 35 | 50 MB
MAX-VAC.COM

WARNINGS

This appliance has been designed to be used by adequately trained persons,
specifically on cleaning and maintenance of the appliance, the risks deriving
from vacuumed materials and their proper disposal, and replacement of spare
parts according to the directives in force in the various countries.
Do not vacuum flammable, potentially explosive or corrosive substances and
incandescent ash. These substances may compromise safety and operation of
the appliance.
Never put the power cable on sharp edges, do not crush it and keep it away
from the rotary electric brushes
If the power cable is damaged, it must be replaced by
the manufacturer or approved technical service centre
or in any case by a person with similar qualification so
as to prevent any risk.
Only use the socket outlet on the machine for purposes specified in the
instructions.
For the electric tools connected to the socket of the vacuum cleaner, follow the
relative instructions for use.
In the event of leaks (foam or liquid) immediately turn off the appliance.
DV 20 | 35 | 50 MB
MAX-VAC.COM 9