Wire Diagram - CAB HYBRA 24 Manual De Instrucciones

INDEX

1) WIRE DIAGRAM .........................................................................................19

2) ENCODER WIRING .....................................................................................20
3) AUTOSET ..................................................................................................20
4) PROGRAMMING ........................................................................................20
5) PARAMETERS, LOGIC AND SPECIAL FUNCTIONS .......................................21
5.1 PARAMETERS (PAR) ......................................................................... 21
5.2) LOGIC (LOG) .................................................................................... 22
5.3) RADIO (RAD) ................................................................................... 24
5.4) CYCLES NUMBER (NMAN) ................................................................ 24
HYBRA 24 CONTROL UNIT
ARC CONTROL UNIT
IMPORTANT, PLEASE READ CAREFULLY:
The radio receiver in this product is compatible ONLY with the new ARC (Advanced Rolling Code) transmitters which, thanks to 128-bit encryption
ensure superior copy-security.
Storing new ARC transmitters is quite similar to that of normal rolling code transmitters with HCS coding
1) WIRE DIAGRAM
Wire connections shown in Fig. 1 are described hereunder:
Terminal Function
L-N-GND
Power supply
M4 Power supply selection
+ 24V - Output 24Vdc
+BAT-
Batteries
Terminal No. Function
1-2 Motor 1
3-4 Motor 2
5-6 Flashing light
7-8 Lock
9-10 AUX1
11-12 24 Vdc
13-17 Limit switch inputs
18 PHOT
19 PHOT C
20 STOP
21 OPEN
22 CLOSE
23 PED
24 Step-by-Step
25 COM
26 -
6) TRANSMITTERS REMOTE LEARNING .........................................................25
7) FUSES ....................................................................................................25
8) BACK UP BATTERIES .................................................................................26
9) DIAGNOSTICS ...........................................................................................26
10) ERROR MESSAGES .................................................................................26
SAR.24V
Description
Power supply input (115V ± 10% or 230V ± 10%) selectable via terminal M4
WARNING: to use the central unit with 115V power supply, it is necessary to jumper this terminal.
Controller HYBRA 24 power supply output 24 Vdc
Clamp input for connection of back-up batteries (accessory).
HYBRA 24
Description
Connection, motor 1: 24VDC 16A max
Connection, motor 2: 24VDC 16A max
Connection, flashing light 24VDC 15W max.
Output, 12Vdc/10W power supply for electric lock (7:0V, 8:+12V)
N.O. contact free from voltage can be configured via the AUX1 parameter as:
Open gate indicator (SCA), second radio channel (2nd CH), courtesy light (TLS), zone light, photocell
test contact (PHOTEST).
See parameter AUX1
Output, accessory power supply, 24VAC/0.5A max.
Make sure the devices are correctly connected (i.e. 11:+24Vdc / 12:-0Vdc).
Do not use the limit switches in this version. DO NOT REMOVE the jumpers.
Input, photocell activated in both opening and closing phases
Input, photocell activated in closing phase only (Normally closed contact)
Input, STOP push-button (Normally closed contact)
Input, OPEN push-button (Normally open contact).
It is possible to connect a timer for opening in time slots.
Input, CLOSE push-button (Normally open contact)
Pedestrian button input (N.O. Contact), controls the motor 1 opening, see TPED parameter.
Input, step-by-step push button (Normally open contact)
Common for Limit switch and all the command inputs.
Input - Encoder Motor 1
5.5) MAINTENANCE CYCLES (MACI) ....................................................... 24
5.6) RESET (RES) ................................................................................... 24
5.7) AUTOSET (AUTO)............................................................................. 24
5.8) PROTECTION CODE (CODE) ............................................................. 25
EN
17