Maintenance; General Maintenance; Lubricating The Machine - EGO SNT2120AP Manual Del Operador

MAINTENANCE

WARNING:
the product when cleaning or performing any maintenance.
WARNING:
parts may create a hazard or cause product damage. To ensure safety and reliability, all repairs
should be performed by a qualified service technician.
NOTICE:
Periodically inspect the entire product for damaged, missing, or loose parts
such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do
not operate this product until all missing or damaged parts are replaced.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.

LUBRICATING THE MACHINE

All of the bearings in this product are lubricated with an amount of high grade lubricant
sufficient for the life of the unit under normal operating conditions. Therefore, no further
bearing lubrication is required.
REPLACING THE SCRAPER BAR
WARNING:
performing any maintenance task on your snow blower.
Required tools (not included):
◾
5/16" (8 mm) open-end wrench
◾
T20 Torx screwdriver
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120AP/SNT2120AP-FC
To avoid serious personal injury, always remove the battery pack(s) from
When servicing, use only identical replacement parts. Use of any other
Do not at any time let brake fluids, gasoline, petroleum-based products,
Make sure to turn off the unit and remove the battery pack(s) before
27