Clearances And Dimensions - Midea MGS30S2AST Instrucciones De Instalación

The power cord of this product is equipped with a 3-prong (grounding)
plug which mates with a standard 3-prong grounding wall receptacle to
minimize the possibility of electric shock hazard from this appliance.
The wall receptacle is to be connected to a properly grounded dedicated
circuit providing 120 VAC/60 Hz power and protected by a 15- or 20-Amp
circuit breaker or slow blow fuse.
Where a standard two-prong wall receptacle is encountered, contact a
qualified electrician to have it replaced with a properly grounded
three-prong wall receptacle. Do not use an adapter plug.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE THIRD
(GROUND) PRONG FROM THE POWER CORD.
Regarding GFCI outlets: Ground Fault Circuit Interrupters (GFCI) are not
required or recommended for gas range receptacles. GFCIs are devices
that sense leakage of current in a circuit and automatically switch off
power when a threshold leakage level is detected. These devices must
be manually reset by the consumer. The National Electrical Code only
requires the use of GFCI's in kitchen receptacles installed to serve
countertop surfaces. Performance of the range will not be affected if
operated on a GFCI-protected circuit but the occasional resetting of the
circuit can become an annoyance.

Clearances and Dimensions:

• This range has been designed to comply with the maximum allowable
wood cabinet temperature of 194 °F (90 °C). Make sure the wall
coverings, countertops, cabinets, and any other materials in contact
with the range are rated for a minimum of 194 °F (90 °C). If not,
discoloration, delamination, or melting may occur.
Before starting the installation process, confirm the installation space
meets the following dimensions and clearances. Do not locate the range
where it may be subject to strong drafts - seal any openings in the wall,
floor, or cabinets in the installation space. Provide adequate clearances
between the range and adjacent combustible surfaces. These dimensions
must be met for safe use of the range. The given dimensions provide
minimum clearance. Contact surface must be solid and level.
The minimum clearance is 0" for the rear of the range. Follow all
dimension requirements to prevent property damage, potential fire
hazard, and incorrect countertop and cabinet cuts.
16