Cooktop Operation - Midea MGS30S2AST Instrucciones De Instalación

Cooktop Operation:

Check the operation of all cooktop burners after the range has been
installed and assembled, gas supply lines have been carefully checked for
leaks, and electrical power cord has been plugged in. All surface burners
have electronic ignition.
To purge any air that may remain inside the range gas tubing, it is
recommended to confirm the operation of cooktop burners first.
Directions:
• For each burner, one at a time, rotate the knob to the "LIGHT" position
- confirm that clicking is heard and visually observe that electrode is
sparking properly to the burner cap.
• Allow a few seconds for the burner to ignite, and observe flame quality.
• Light all surface burners and set all to the highest setting.
• For each burner, one at a time, rotate the knob quickly to the lowest
setting - confirm that the flame is not extinguished.
• With one burner still at the lowest setting (and all others at highest
setting), quickly open and close the oven door - confirm that the flame
is not extinguished.
• Compare flame height at the highest and lowest setting - confirm flame
height is sufficiently reduced when turned to the lowest setting. In
other words, confirm that the lowest setting is sufficiently low for the
size of the burner being tested.
• Repeat until all burners are confirmed.
operation.
LP gas operation.
Abnormal for any gas
operation; call for service.
NOTE
use.
Normal for natural gas
Normal for
33