Securing The Lid Stopper; Assembling The Lid Handle; Installing The Thermometer - Pit Boss AUSTIN XL Instrucciones De Montaje Y Funcionamiento

• Next, open the main grill lid and remove the four screws in the center
of the large diffuser plate. Remove from the main barrel and set aside.
Adjust the rotation as needed to align the screw holes of the main
barrel to the cart. Once placed, secure each leg to the main grill barrel
using three screws, locking washers, and washers. After the legs are
secure, use six (G) screws to secure the front and back panel to the
main grill barrel. Note illustration 4B.
NOTE: When aligned properly, the main grill should be sitting level
and secure on the cart.
• Replace large diffuser plate in main barrel, and secure using previously
removed four screws. Note illustration 4C.

5. SECURING THE LID STOPPER

Parts Required:
1 x Lid Stopper (#11)
Installation:
• Secure the lid stopper onto the top of the main barrel using the pre-
installed screw on the top of the main barrel.

6. ASSEMBLING THE LID HANDLE

Parts Required:
1 x Lid Handle (#7)
2 x Lid Handle Bezel (#6)
Installation:
• Remove the pre-installed screws from the lid handle. From inside the
barrel lid, insert one screw to protrude to the outside. Add a bezel on
the screw, then hand-tighten the screw (from the inside) into the lid
handle. Repeat for the other side.

7. INSTALLING THE THERMOMETER

Parts Required:
1 x Thermometer Kit (#10)
Installation:
• Remove the pre-installed nut from the thermometer.
• Insert the thermometer into the hole provided on the top of the lid on
the main barrel, then secure by re-installing the nut from the inside.
Rotate the thermometer so the text is level and upright.
NOTE: If rotation is askew, this will result in incorrect readings.
4B
G
G
A C B
4C
5
11
6
6
7
7
10
G
9