Installation Method - Artlii Play3 RD-835 Manual De Instrucciones

Projector Installation

Installation method

The projector can be hung by a special hanger on the ceiling in
the forward direction according to your operational environment
and demands, or placed on a stable table to project image onto
the screen in the forward direction. Of course, you can also install
the projector with other methods according to the following diagram.
Attentions
1) The projector should not be higher than the upper side of the
screen if being hung on ceiling; otherwise, it may affect image effect
and trapezoid correction.
2) The projector must be installed along the right-and-left symmetric
axis of the screen to avoid image showing right-and-left trapezoid
distortion
3) The projector should be installed in a draughty position, and there
should be no any object to cover or block the air vent of the projector.
4) Hot-line work is unallowable during installation, to avoid electric
shock hazard or circuit fault of the projector.
Projector Installation
Standard settings (Front projection)
The projector should be placed on a solid and stable table or
on ceiling by a mount during installation. It should be installed
in a draughty position, to avoid any object covering or blocking
the air vent. Any object should not be within 30 cm away from
the air vent.
Note:
To avoid the projection image showing geometric distortion
(showing trapezoid state) after installation, the projector should
be installed vertically along the right-and-left symmetric axis
of the screen. See the following diagram.