Installation And Setup - Osmofilter Blue Ocean Manual De Instrucciones

INSTALLATION AND SETUP

During installation, the water dispenser Blue Ocean must be disconnected from the electricity.
1. If the pressure is not at least 3 kg/cm2, you need a pressure pump
2. Be sure to connect the water dispenser to a room temperature and potable inlet water.
3. Install a faucet in the network inlet for maintenance.
4. Connect the water oultet to the drain with a 1/4" tube.
5. Connect the drain to water outlet. Do not rise up the drain above the water outlet.
6. Disconnect the activated carbon water outlet and the water inlet.
Remove the frontal cap. Plug the water dispenser and open the water inlet. Wash the activa-
ted carbon cartridge during 5 minutes until the water is clear.
7. Unscrew the membrane housing cap and inset the membrane. Screw the membrane
housing cap and connect the tube. Open the water inlet and be sure there is no water leaks
and the equipment is producing osmotized water.
8. Close the water faucet and wait until the tanks are full, then empty the tanks with the faucets.
05