Installation Of The Equipment; Installation Warnings; System Installation - Osmofilter Blue Mountain Manual De Usuario

INSTALLATION OF THE EQUIPMENT

9. INSTALLATION WARNINGS

The water source must be disconnected electrically
during the entire installation.
DO NOT turn on the hot water switch until the
second filling is done to avoid breakage in them
resistor.
DO NOT turn on the cold water switch if not needed.
Every time you need to turn off the equipment,
please wait at least 3 minutes to reconnect it. That
way you can protect the compressor from any
possible damage.
Water temperature setting:
The temperature is set at 5 ° C. You can change the
cooling temperature from the cold water regulator. If
you turn the screw clockwise, the water will get
cooler.

10. SYSTEM INSTALLATION

1.
First, you must disconnect the water supply; find the
machine in the packaging bag and connect it to the
accessible water supply.
2.
Secondly, find the water inlet ball valve from the
packing bag and install it on the side of the machine,
making sure it is securely fixed and turn it off. Next,
connect the PE pipe to the raw water inlet pipe of the
R.O. water dispenser.
3.
Find a PE pipe of a certain length. Connect one side
of the PE pipe to the wastewater outlet of the water
dispenser and the other side of the PE pipe is
connected to the groundwater drain.
4.
Please open the water dispenser door, disassem-
bling the R.O. membrane water inlet pipe, water inlet
pipe and rear activated carbon filter outlet pipe.
Then, let the outlet pipe of the front activated carbon
filter connect well to the inlet pipe of the rear
activated carbon filter.
5.
Let the outlet pipe of the downstream activated
carbon filter be connected to a large water pressure
tank to store the purified water.
6.
In the meantime, remove the reverse osmosis
membrane from the packing bag; allow one side to
attach tightly to the reverse osmosis cartridge,
making sure they are well sealed. Then rinse the
inside of the cartridge, you can close the water inlet
ball valve once the dirty water becomes clean.
7.
Turn on the power plug, open the two water drain
covers on the back of the machine until the machine
fills with water, just to clean the water dispenser.
NOTES:
1.
Please make sure the machine is under the power of
230 V AC, 50Hz.
2. If the power is disconnected for any reason, please
wait five minutes before reconnecting.
3.
Regular cleaning and sanitizing is advised to ensure
continued quality of water drinking.
4. Before turning on, please check the power label on
the rear of the unit to ensure the power supply is
correct. Serious damage could be happed if the
incorrect supply is used.
5.
Never put cigarettes on the top of the water dispen-
ser. Don't use it as a shelf for plants or putting other
objects on it.
6.
Don't locate water dispenser in area where the
temperature may fall below freezing. The suitable
surrounding temperature is 10
happened, let water dispenser stand for a few
minutes to allow any ice in the reservoir to melt. Add
hot water to speed up this process, and at the same
time, keeping the power off for a long period if no
one uses it, which saves energy and prolongs the
lifetime of the compressor.
5
EN
to 32 . If ice-jam