Eldom press DA36 Manual De Instrucciones página 12

IRONING WITHOUT STEAM
Before plugging in the iron to the mains, place it on the base (8), set the thermostat knob (10) in the "OFF" position,
and the steam regulator (3) in the "0" position (no steam).
Plug in the iron to the mains: the light (9) will go on.
Set the temperature with the thermostat knob (10).
Ironing can be started when the light (9) changes color - it means that the iron has reached the required
temperature
The thermostat will maintain the selected temperature, which will be signaled by a color change (9).
IRONING WITH STEAM
Ironing with steam and the steam shot function is only possible when high temperature is set.
The highest temperature is marked "MAX" on the thermostat knob (10).
Intensity of steam is et with the regulator (3).
The button (4) may be used to release additional volume of steam. The additional steam shot facilitates ironing of
exceptionally resistant creases.
NOTE.
Steam is hot. Danger of scalding or burns.
The sole of the iron (13) is heating up very quickly and needs more time to cool down. It must not be touched
FILLING THE WATER TANK
Before filling or refilling the tank (11) with water, make sure that the plug is removed from the socket and that the
steam intensity regulator (3) is set to the "0" position.
Pour clean tap water at room temperature into the iron.
For filling the iron tank use the supplied container adapted in shape to the inlet opening.
Do not pour water into the iron directly from the tap!
When pouring water into the iron, remember that the water level should not exceed the "MAX" mark on the
tank (11).
ANTI-CALC SYSTEM
A special filter inside the water tank softens the water and prevents limescale from settling on the soleplate. The
filter is durable and does not require replacement.
Caution:
Use only tap water. Distilled and demineralised water makes the anti-calc system ineffective, changing its
physicochemical properties.
SPRAYER
After water is poured into the tank (11), it may be used to sprinkle the ironed spot with the button (5).
ANTI DRIP
The ANTI DRIP function prevents water from dripping from the sole (13) when the iron temperature is too low to
produce steam.
SELF CLEAN
Using the sole self-cleaning function is recommended to prevent scale setting in the iron. To do this:
- fill in the iron full with water,
- plug in the iron to the mains and set the thermostat (10) at "MAX",
- and switch on the unit when the light (7) goes off,
- in the horizontal position, e.g. above the sink, press the SELF CLEAN button (12) for about a minute and shake the iron,
- when the iron cools down, wipe the sole with a damp cloth to remove soiling.
CLEANING
Before cleaning, plug out the iron and wait for it to cool down completely.
- The iron must not be immersed in water.
- The iron must not be cleaned with rough, abrasive cloth or sponge, as it may destroy the device.
- Wipe the iron body and the soleplate (13) with a damp cloth and then dry with a clean cloth.
12