Toyotomi KR-47 Instrucciones De Uso página 12

5
Stop filling by loosening the valve on top of the pump (turn anti-clock-wise),
once the gauge indicates that the tank
6
Remove the siphon carefully, allowing the excess paraffin to drain from the
tube back into container. Replace the fuel tank cap and tighten it securely (Fig.
H). Be sure to wipe away any spilled paraffin from tank or other heater parts.
!
Be especially careful to avoid overfilling the tank with very cold paraffin; other-
wise overflow might occur when the fuel warms up.
C
IGNITING THE HEATER
When you first use your new heater, ignite it out of the living area of your house,
!
either in a garage or an outside area protected from strong drafts. Burn it for
about 15 minutes to remove all of the protective oil present on the burner parts.
If this 15 minute "burn-in" is done inside, some objectionable odour will be
observed. This procedure is necessary ONLY THE FIRST TIME you ignite your heater.
If you have fuelled your heater for the first time, or if you are refuelling it after
!
it has been out of fuel for a long time, you will need to wait about thirty (30)
minutes for the wick to become fully saturated before lighting. Failure to allow
enough time for the wick to become fully saturated may cause permanent dama-
ge to the wick when it is lighted.
Always ignite the heater with the igniter slide. Never use matches or cigarette lighters.
Follow the procedure below:
1
Turn the wick adjuster knob clockwise until it stops (Fig. I). The automatic
extinguisher is engaged automatically by turning the wick adjuster clockwise.
This raises the wick to its maximum height. As the wick rises within the heater,
the wick adjuster knob turns with some resistance and makes a sound like the
winding of a clock. Once the wick has reached its proper height, the automatic
extinguisher is fully engaged.
2
Gently push down the igniter lever
touch the wick. When flame appears, release the igniter lever. The wick adjus-
ter knob will now move freely left or right to adjust the flame.
!
If you have difficulty igniting the wick, push back the igniter lever very slightly
to remove the igniter coil form direct contact with the wick.
After having ignited the heater, always check whether the combustion
!
chamber ¿ is level, by sliding it slightly to the left and the right by its handle
´ (Fig. K). This should be a smooth movement. If the combustion chamber is
not level, this will cause smoke and soot to develop.
4
6
is full (Fig. G).
(Fig. J). The igniter coil should glow and
H
I
J
K