Tools And Parts - ELICA KIT0179549 Guía De Instalación, Uso Y Mantenimiento

Gather the required tools and parts before starting the
installation. Read and follow the instructions provided with
any tools listed here.
Tools/Materials required
• Drill
• 1 ⁄ " (3 cm) drill bit
1
4
⁄ " (0.5 mm) drill bit
• 3
1 6
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Pliers
• Caulking gun and weatherproof caulking compound
• Vent clamps
• Jigsaw or keyhole saw
• Metal snips
• Screwdrivers
•
Phillips
•
Flat-blade
Supplied Part
Strain relief connector (13.5)
4.2x8 mm screws
6-wire blower connector
4x1.8mm flat washers
Spring tab
6.3 x 60 mm screws
Support bracket
10x50 mm wall anchors

Tools and parts

Parts not supplied
• 6 AWG wires, one each of the following colors: black, white,
red, blue, gray, and green/yellow (ground)
NOTE: The length of the conduit and AWG wires is
determined by the distance between the in-line blower
motor and range hood terminal boxes.
• 11 - UL listed wire connectors.
Parts supplied
Removing parts from the packages. Check that all parts are
included.
• Shell for blower motor assembly
• Hardware bag with:
Pieces
2
33
1
4
1
7
1
7
Supplied Part
6.5 X 3.5 mm screws
Ø 12 mm strain relief
6x13.5 mm
Torx adapter
Clip nuts
Strap 2.5x 95 mm
6 x 16 mm screws
Pieces
10
1
2
(T10)1
(T20)1
4
3
4
5