Shark AI ULTRA ROBOT RV2600WSEU Manual De Instrucciones página 32

PREP YOUR HOME
Your robot uses an array of sensors to navigate around walls, furniture legs, and other obstacles while it
cleans. To prevent the robot from entering areas you don't want it to, set up no-go zones in the app. For
best results, prepare your home as indicated below, and schedule a daily cleaning to ensure all floor areas
are regularly maintained.
OBSTRUCTIONS
Clear cords and small objects
less than 11.5 cm in height,
and open interior doors to
ensure a complete map of
your home.
THRESHOLDS
Your robot can climb over
most thresholds to get from
room to room, but if one is
too high, set up a no-go zone
in the app to block it off.
STAIRS
For your robot's cliff sensors
to work properly, all runners,
rugs, carpets, or small
thresholds (like child gates)
must be 20.5 cm from any
stairs (or must be continuous
and extend over the edge of
the stairs). If a runner, rug,
carpet, or small threshold
that is less than 20.5 cm from
the stairs cannot be moved,
you must use a no-go zone
or a BotBoundary® strip to
block off the stairs.
MANUAL CLEANING MODE
To manually start a cleaning cycle, press the Clean button on the robot or on the mobile app. To
immediately send the robot back to the dock, press the Dock button.
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your robot on a small
section of the floor to ensure there is no scratching.
s h a r kc l e a n . e u
SCHEDULING
Schedule whole-home
cleanings with the app. To
schedule a mopping run with
the app, the Vac & Mop 2-in-1
Dust Bin must be filled and
installed in the robot with the
pad attached.
AVOID MOVING THE
ROBOT OR DOCK
While your robot is cleaning,
do not pick it up and move it,
or move the charging dock—
this will impact the robot's
navigation and ability to
return to dock when cleaning
is complete.
After setup is complete, follow instructions in the
app to help your robot conduct an Explore Run to
create an initial map of your home. Ensure the
REMOVE RUGS FROM
Self-Empty Dust Bin is inserted for the Explore
DOORWAYS WHEN
Run.
MOPPING
Before mopping, we The robot will travel from room to room to identify
recommend setting up walls, furniture, and other obstacles as it cleans.
Carpet Zones in the app, and This run will take less time than a full cleaning, as it
moving any carpets or rugs doesn't cover the entire floor.
that block access to floors
that you want your robot to
mop.
To vacuum with the Self-Empty feature, use the
Self-Empty Dust Bin. Do not install the Vac & Mop
2-in-1 Dust Bin.
USING THE SHARK® AI ULTRA 2-IN-1 ROBOT
AI LASER NAVIGATION™
The robot's object detection technology helps it
navigate around obstacles taller than 11.5 cm in
height. Clear away small objects that may interfere
with the cleaning path of your robot.
Create no-go zones in the app to block off areas you
do not want the robot to enter.
VACUUM-ONLY INSTRUCTIONS
NOTE: Be sure to charge the robot completely before
its first cleaning so that it can explore, map, and clean
as much of your home as possible. It may take up to 6
hours to fully charge your robot.
NOTE: Avoid moving the dock. If it is relocated, the
robot may not be able to find its way back to the dock.
If the robot is relocated while in use, it may not be able
to follow its intelligent cleaning path, or find its way
back to the dock.
s h a r kc l e a n . e u