Intended Use; Starting + Stopping; Care & Maintenance - sunjoe 24V-CTC-LTE Manual Del Operador

Operation

Intended Use

The 24V-CTC-LTE is designed to clean moss, lichen, weeds and
unwanted debris from path edges, patios, blocks and between
paving slabs. Use the nylon brush for more delicate surfaces
such as wood and the wire brush for tougher surfaces such as
stone or concrete.
Do not use this product in rain or wet conditions.
For safety reasons, read the entire instruction manual before
using the tool and to observe all the instructions contained
within this manual.
This product is intended for domestic use only. It is not intended
for commercial use. It must not be used for any purposes other
than those described.

Starting + Stopping

m
WARNING!
The rotating brush may cause serious injury.
The brush will continue to spin for a few seconds after the
tool has been switched OFF. Do not touch the spinning brush.
Contact with hot components (i.e. motor housing, gear box, etc.)
on the machine may cause burns. Allow the machine to cool
before handling.
1. Slide the battery pack into the battery compartment on the
handle of the weed sweeper until it clicks into place (Fig.
12).
Fig. 12
Battery compartment
2. To turn on the tool, push the safety lock forward with your
thumb, then squeeze the trigger. Once the tool is running,
release the safety lock (Fig. 13).
Fig. 13
3. Use your cordless weed sweeper to clear moss, weeds and
other debris on or between various surfaces such as paving
tiles as shown below (Fig. 14). Sweep away from yourself
in small, steady strokes and let the tool do the work. Do not
apply excessive force.
Fig. 14
4. Release the trigger to turn off the tool (Fig. 13).
Care + Maintenance
m
WARNING!
Always switch the product off, remove the
battery, and let the product cool completely before inspecting,
cleaning, or performing any other maintenance task.
m
WARNING!
Wear gloves when working on or near the
power tool as parts such as the wire brush are pretty prickly.
Use appropriate tools when necessary; never use your bare
hands!
m
WARNING!
Only perform the repairs and maintenance
work described in this manual. Any other work must be
performed by a qualified technician.
9
Safety lock
Trigger