Danby Designer DDEF02213BD13 Manual Del Propietário página 10

INSTALLATION INSTRUCTIONS
PREPARATION
WARNING: This product includes glass. Always use extreme caution
when handling glass. Failure to do so could result in personal injury or
property damage.
Remove all parts and hardware from the carton and place them on a
clean, soft, dry surface.
WARNING: Make sure all parts are dry and the power cord and plug
are not damaged. See the Important Instructions section.
The fi replace can be wall-mounted or placed on a solid, level surface
when the free standing feet are assembled. The fi replace must be
plugged into a 120V 60Hz electrical outlet.
FREE STANDING FOOT ASSEMBLY
Place the fi replace carefully on its back. Place the fi replace on a blanket
or soft surface to avoid scratching the unit or fl ooring.
Attach the free standing feet using eight 4 x 16 mm screws as shown.
Place upright on a solid, level surface and plug into a 120V 60Hz
electrical outlet.
Note: If you attach the solid feet for freestanding installation, you do not
need to install the wall bracket onto the back of the fi replace.
9