Care And Cleaning; Troubleshooting; Accessories - Kreg PRS1000 Manual Del Propietário

Care and Cleaning

■
Wipe the profile templates (E, F) and base plate (A) clean of any dust and debris.
■
Clean the back base plate (A) with the GrippMaxx™ material with a damp cloth to keep it
clean and clear of saw dust and debris.
■
Keep the profile templates (E, F) in the profile case (D) to prevent loss.
■
Clean the router bit of dust and debris after use.

Troubleshooting

Problem
Experiencing Chip Out
Experienced shifting or
movement of baseplate
Baseplate does not align to
material edge

Accessories

Kreg Flush-Trim Bit - 1/4" Shank (PRS250)
Solution
Make multiple small passes to minimize the material removed.
Bit may be dull and require replacement, see Kregtool.com for PRS250/
PRS500 replacements.
GrippMaxx™
Clean the
Make sure the edge stop posts all are aligning to the material edge.
Clamp the baseplate in place to the material for hand router use.
Ensure material thickness is at least 1/2" in thickness and 3.5" in width, and at
least 7" in length for minimal material use.
material on the underside of the base plate.
Kreg Flush-Trim Bit - 1/2" Shank (PRS500)
7