Chef'sChoice EdgeCraft 220DC Manual De Instrucciones página 4

CHARGING THE DC 220 SHARPENER
Plug the adapter into the sharpener, then plug the cord into a wall outlet. For Optimum
Performance and Battery Life, charge fully before use. The battery takes 45-60 minutes to
recharge. One battery charge will last for up to 45 minutes of continuous sharpening.
Use only with Listed/Certified ITE Power Supply. Do not use an extension cord. Plug
charger directly into electrical outlet. Use only with the charger provided with the
appliance. Do not attempt to use this charger with any other product. Likewise, do not
attempt to charge this appliance with any other charger. Carefully route the power supply
cord to avoid damage from the knife blades while sharpening.
WHEN PLUGGED IN AND TURNED OFF:
Blinking Green
Solid Green
WHEN PLUGGED IN AND TURNED ON:
Blinking Green
Solid Green
WHEN UNPLUGGED AND TURNED ON:
Solid Green
Blinking Red
Solid Red
ON/OFF POWER SWITCH
The power switch positions are indicated by the "I" and "O" symbols. See symbols below.
Figure 1. Inserting the blade in the left slot of
the Stage 1. Alternate individual pulls in left and
right slots.
charging
fully charged
charging and running
fully charged and running
not charging and running
low battery, turn off and charge at least 3-5 min
battery is dead, turn off and charge at least 3-5 min
Symbol for OFF position Symbol for ON position
Figure 2. Inserting the blade in the right slot of
Stage 1. Alternate pulls in left and right slots.
English — 4