Maintenance - Vacmaster VZA0708P Manual De Instrucciones

GB
WARNING:
CARRYING OUT ANY MAINTENANCE.
1) Keep all safety devices, air vents and the motor housing free of dirt and dust. Use a soft, dry
brush to clean the equipment regularly.
2) Clear all dirt or debris from the collection tank after each use. Allow to dry before replacing the
power head. Do not use cleaning agents or solvents; these may damage the appliance.
3) Check the suction hose, attachments, and power cord to verify that they have not been
damaged or any debris is trapped and blocking airflow.
1. Cleaning the Pre-filter
1) Remove the pre-filter and clean by gently tapping or brushing dirt off. For optimal performance
it is recommended to replace the old filter with a new filter regularly.
2) Rinse the pre-filter with clean water. Allow the filter to completely dry before re-installing. DO
NOT install a pre-filter if damp, this may cause damage to the appliance.
2. Cleaning the Air Inlet Filer
1) Remove the air inlet filter from the securing tabs by using the pull tab (Fig. 11).
2) To wash the air inlet filter, rinse with clean water. Allow the filter to completely dry before
re-installing.
3) For optimal performance it is recommended to replace the old filter with a new filter regularly.
NOTE:
Make sure that the pre-filter and air inlet filter are completely dry before use.
3. Cleaning & Replacing HEPA Exhaust Filter
1) Unlock the exhaust filter cover by lifting both of locking tabs upwards to release. Pull the door
out (Fig. 12).
2) Remove the exhaust filter from the vacuum cleaner and clean by gently tapping off any lose
debris. For optimal performance it is recommended to replace the old filter with a new filter
regularly (Fig. 13). Rinse the exhaust filter with clean water. Pay attention not to rub or brush
the filter while cleaning. Allow the exhaust filter to completely dry before re-installing.
3) Install the cleaned or new filter. Then insert the filter cover tabs into the upper slots and lock the
filter door into place. You will hear a click if the filter door installed correctly.
4. Storage
1) Retract the power cord by rotating the cable rewind clockwise (Fig. 14).
NOTE:
To avoid the power cord from getting stuck, do not retract the line too fast.
2) The floor nozzle has a storage hook that slides into the allocated slot on the collection tank
(Fig. 15).

MAINTENANCE

REMOVE THE POWER CORD FROM THE POWER SUPPLY BEFORE
12