TAKATA MIDI I-SIZE PLUS Manual De Instrucciones página 16

CAUTION!
Whenever you adjust the seat, check that the slider is
locked into position again. To do this, gently try to
move the slider up or down, without pushing it in.
Adjust seat reducer for babies
The seat reducer for babies can be individually
adjusted in stages to ensure your child is in exactly the
right position in the seat. It consists of two upholstered
pads (one of which is foldable), the body support
insert and the head support insert.
[MIDI_I-SIZE_PLUS_056 a] Both pads, the
body support insert and the head support insert
(in the lower attachment position on the body
support insert) will be required from birth up to
approx. 60 cm.
[MIDI_I-SIZE_PLUS_056 b] The lower pad can
removed from approx. 61 cm to approx. 75 cm
and the head support switched to the upper
attachment position on the body support insert.
WARNING!
[MIDI_I-SIZE_PLUS_048 a + b] Always ensure that
Loosening the straps and opening the buckle
Before placing your child in the MIDI I-SIZE PLUS
child car seat or removing your child from it, loosen
the straps and open the buckle. The MIDI I-SIZE
PLUS features a central lever that is used to loosen the
straps.
WARNING!
[Magnets] This product contains magnets to make it
easier to secure and unfasten the child. Wearers of
electrically active implants (for example, pacemakers)
these magnets as this could result in electromagnetic
inference. If you are unsure, please contact your
paediatrician or GP. Additional information is available
on our website under FAQ.
Step 1 – Unblock the straps
[MIDI_I-SIZE_PLUS_021] To loosen the straps, pull
the lever up and hold it in this position.
Step 2 – Loosen straps
At the same time, pull the shoulder straps gently
forward as far as possible.
Step 3 – Open the buckle
[MIDI_I-SIZE_PLUS_022 a] To open the buckle,
press the red button on it, and remove the tongues. The
buckle can be folded down and held in position by the
magnets making it easier to lift your child in and out
of the seat.
[MIDI_I-SIZE_PLUS_022 b] The two tongues are
held together magnetically and can be easily separated
by pulling them apart and attached on the outside of
the seat shell also using the magnets.
Adjusting the seat inclination
[MIDI_I-SIZE_PLUS_023 + MIDI_I-SIZE_PLUS_024]
The inclination of the forward facing MIDI I-SIZE
PLUS can be adjusted by pressing the seat inclination
lever below the front end of the shell upwards. Keep
the seat inclination lever pressed, and at the same
time, pivot the shell up or down at the front end. Then
release the seat inclination lever again so that the seat
shell is locked in upper or lower position. This is
indicated by a click.
CAUTION!
Whenever you adjust the seat inclination, check that
the seat shell and lever are locked into position again.
To do this, gently try to move the front end of the shell
up or down, without pressing the inclination lever.
NOTE!
The inclination of the seat can only be adjusted when
installing the MIDI I-SIZE PLUS forward facing on
the I-SIZE BASE (PLUS).
If it is not possible to install the MIDI I-SIZE PLUS
rearward facing on the I-SIZE BASE (PLUS), please
kindly check the position of the inclination. If
necessary, change the inclination and install the MIDI
I-SIZE PLUS rearward facing on the I-SIZE BASE
(PLUS) again.
NOTE!
The forward facing usage mode is only possible after
removing both safety caps. Forward facing usage of
the MIDI I-SIZE PLUS is only allowed if the child's
age exceeds 15 months.
I-SIZE BASE (PLUS)
For basic instructions regarding the I-SIZE BASE
(PLUS) (adjustments, securing in and removing from
the vehicle) please read the respective section in the
instruction manual of the I-SIZE BASE (PLUS).
de
en
en
fr
it
es
pt
nl
17