Declaration Of Conformity - ESAB Origo Mig L305 Instrucciones De Uso

The Low Voltage Directive 2006/95/EC of 12 December 2006, entering into force 16 January 2007
The EMC Directive 2004/108/EC of 15 December 2004, entering into force 20 July 2007
Type of equipment
Welding power sources for MIG/MAG welding
Brand name or trade mark
ESAB
Type designation etc.
TM
Origo Mig L305
TM
Origo Mig L405
Manufacturer or his authorised representative established within the EEA
Name, address, telephone No, telefax No:
OZAS−ESAB Sp. z o.o.
ul.A.Struga 10 , 45−073 Opole , Poland
Phone: +48 77 4019200, Fax: +48 77 4019201
The following harmonised standard in force within the EEA has been used in the design:
EN 60974−1, Arc welding equipment – Part 1: Welding power sources
EN 60974−10, Arc welding equipment – Part 10: Electromagnetic compatibility (EMC) requirements
Additional information: Restrictive use, Class A equipment, intended for use in locations other than residential
By signing this document, the undersigned declares as manufacturer, or the manufacturer's authorised
representative established within the EEA, that the equipment in question complies with the safety
requirements stated above.
Place and Date
Opole , 2012−03−20

DECLARATION OF CONFORMITY

In Accordance with
Valid from serial number 647−xxx−xxxx (2006 w.47)
Valid from serial number 628−xxx−xxxx (2006 w.28), 211−xxx−xxxx (2012 w.11)
Signature
Dariusz Brudkiewicz
Clarification
- 2 -
Position
Managing Director
OZAS−ESAB Sp. z o.o.