Low Boost; Super Filter - Roland SPD-SX PRO Manual De Referencia

Effect List (English)

Low Boost

Boosts the volume of the lower range, creating powerful lows.
Parameter
Boost Frequency 50, 56, 63, 71, 80, 90, 100, 112, 125 [Hz]
Boost Gain (*1) 0–+12 [dB]
Boost Width WIDE, MID, NARROW
Low Gain -15–+15 [dB]
High Gain -15–+15 [dB]
Level 0–127
*1: This parameter corresponds to MFX Ctrl. For details, refer to
Ctrl)(P.203)".
*1: This parameter corresponds to MASTER EFFECT CTRL. For details, refer to
EFFECT (MASTER EFFECT CTRL)(P.204)".

Super Filter

This is a filter with an extremely sharp slope. The cutoff frequency can be varied cyclically.
Parameter
LPF, BPF, HPF, NOTCH
Filter Type
-12, -24, -36 [dB]
Filter Slope
0–127
Filter Cutoff (*1)
0–100
Filter Resonance
Filter Gain 0–+12 [dB]
Modulation Sw OFF, ON
TRI, SQR, SIN, SAW1, SAW2
Modulation Wave
170
Value
Value
Type of filter
Frequency range that will pass through each filter
LPF: frequencies below the cutoff
BPF: frequencies in the region of the cutoff
HPF: frequencies above the cutoff
NOTCH: frequencies other than the region of the cutoff
Amount of attenuation per octave
-12 dB: Gentle, -24 dB: Steep, -36 dB: Extremely steep
Cutoff frequency of the filter
Increasing this value will raise the cutoff frequency.
Filter resonance level
Increasing this value will emphasize the region near the cutoff frequency.
Amount of boost for the filter output
On/off switch for cyclic change
How the cutoff frequency will be modulated
TRI: Triangle wave
SQR: Square wave
SIN: Sine wave
SAW1: Sawtooth wave (upward)
SAW2: Sawtooth wave (downward)
Explanation
Center frequency at which the lower range will be boosted
Gain of the lower range that will be boosted
Width of the lower range that will be boosted
Gain of the low range
Gain of the high range
Output Level
"Control del MFX con los mandos PAD EDIT [1] [2] (MFX
"Control del MASTER EFFECT con el mando MASTER
Explanation