Kohler K-19909 Guia De Instalacion página 3

Groove
Rubber Washer
Fiber Gasket
Threaded Ring
Steel Washer
Screw
1. Install the Faucet
Determine the mounting hole location.
Drill a 1-5/16" (3.3 cm) hole through the mounting surface
according to the surface manufacturer's instructions.
Install the rubber washer into the groove through the mounting
hole, then properly position the faucet body.
From under the lavatory, slide the fiber washer and steel washer
onto the shank.
Thread the threaded ring onto the shank to secure the faucet
body to the mounting surface.
Thread the two screws into the threaded ring, then tighten with a
Phillips screwdriver.
Kohler Co. 3 1079092-2-A