CMT ORANGE TOOLS CMT9 Manual De Instrucciones página 8

GB
2. When cutting, if you are not satisfied with the depth of cut, or may want to
adjust it, use the micro-adjusting knob (Fig.3).
3
* Use only the wrench provided with the tool.
1
1. Insert the bit all the way into the collet cone. Press the shaft lock to keep
the shaft stationary and use the open wrench to tighten the collet nut
securely. (Fig.1)
2. To remove the bit, follow the installation procedure in reverse.
SWITCH ACTION (FIG.4)
Caution:
Before plugging in the tool, always check to see that the tool is switched off.
Switch can be locked in "ON" position for ease of operator comfort during
extended use. Apply caution when locking tool in "ON" position and main-
tain firm grasp on tool.
Make sure that the shaft lock is released before the switch in turned on.
1. To start the tool, move the switch lever to the I (ON) position and can
constantly run.
2. To stop the tool, move the switch lever to the O (OFF) position.
8
Micro-
adjusting
knob
Wrench
5
Workpiece
Bit revolving direction
4
www.cmtutensili.com
Feed direction
Switch button