Installation Instructions; Technical Data; Instructions For Positioning - Nordcap SALAMANDER SEH 004 E Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
Model
Type
SEH003E
SEH003E
SEH004E
SEH004E
SEH103E
SEH103E
SEH104E
SEH104E
• Unpack the appliance and check its conditions.
• Before installing the appliance, remove the two screws on the
rear side (pic. 1).
• Place the unit in its position of use and make sure it has enough
distance (at least 10cm) from walls, coverings or other inflam-
mable material.
NOTE - Considering the weight of the appliance, move it very care-
fully. At least 2 people must be there to position the appliance or use
appropriate lifting system.
• If the walls next to the appliance are of inflammable material,
they should be suitably clad.
• Place the Salamandra under a suction hood to guarantee smoke
suction when cooking.
• Important: do not place the Salamandra on a hot surface or releasing steam.
• If necessary, adjust the feet of the Salamandra to place it perfectly at the same level.
• Remove the protective film or remaining glue
DO NOT BLOCK COOLING INTAKES
• If the unit is placed on a table, keep at least 100 mm between the
rear side of the Salamandra and the wall (pic.2)
• If the unit is hanged on a wall, use its fixing brackets and its speci-
fic screws, suitable for its weight
• The wall has to be heat-resistant (up to 80°C) and it must be of
non-flammable material
• Fire prevention regulations must be scrupulously observed.
• The electric wiring must never be under strain. Do not obstruct the
suction inlets or heat dispersion outlets; scrupulously follow the
installation diagrams.
2 • INSTALLATION INSTRUCTIONS
2.1 • TECHNICAL DATA
Rated
Frequency
voltage
[Hz]
[Vac]
3N AC 400
3AC 230
230
3N AC 400
50 / 60
3AC 230
3N AC 400
3AC 230
3N AC 400V
2.2 • INSTRUCTIONS FOR POSITIONING
Total power
Consumption
consump-
[A]
tion [kW]
6,7
4,6
11,6
20
8,9
6,1
15,4
10,3
7,1
17,9
8,6
12,5
21
Ed. 03-22
Cable according to IEC-
60245-57 (H05RN-F
or HO7RN-F).
Minimum cross section
2
of connection cable (mm
)
5x2,5
4x2,5
3x2,5
5x2,5
4x2,5
5x2,5
4x2,5
5x2,5
100
mm
Weight
when
empty
[Kg]
54,5
65
59,2
69,7
Pic. 1
Pic. 2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

437070004

Tabla de contenido