Instructions For Electrical Connection And Unipotential System; Control And Safety System; Start-Up: Recommendations - Nordcap SALAMANDER SEH 004 E Manual De Instrucciones

2.3 • INSTRUCTIONS FOR ELECTRICAL CONNECTION AND UNIPOTENTIAL SYSTEM
The electrical safety of this appliance is guaranteed only if it is connected correctly to an
system, in accordance with current safety regulations. The manufacturer shall not be responsible for any
damage caused by failure to earth the installation properly.
The appliance must also be included in a unipotential system. Make the connection through the terminal
situated on the rear of the appliance, and marked by the relevant symbol, according to current safety regula-
tions.
Before connecting this appliance, make sure that both power supply and frequency are the same as indicated
in the product label.
Connect a plug, suitable to the power consumption and plug it into a socket. Make sure it is correctly con-
• No changes on the wiring system possible.
Safety thermostat
It is activated in case of overtemperature, so that the temperature of all components does not exceed allowed
limits.
Thermostat returns to its state once the temperature has decreased.
ed out as follows:
• Make sure ventilation inlets are clean
• Ensure that current safety regulations have been observed
• Demonstrate to the user the different systems available with the appliance, what routine maintenance is
required and the correct use of the appliance
• Turn on Salamandra and keep it working for some hours. Make sure the room is well ventilated for the
dispersion of smoke
• We recommend advising the customer to sign a maintenance contract
• The possible emission of odor by the Salamander during the first hours of its functioning is to be considered
completely normal as it is due to the high temperature to which the painted parts of the same are subjected.
• During use, the color of the painted parts may undergo variations due to the annealing of the paint.
This is completely normal as it is due to the high temperatures to which the painted parts are subjected and
consequently cannot be considered a defect of the machine.
2.4 • CONTROL AND SAFETY SYSTEM
2.5 • START-UP: RECOMMENDATIONS
22
Ed. 03-22