Reading Actual Values; Gas Volume Flow Regulation; Outlet Pressure Regulation - Abicor Binzel EWR 2 Manual De Instrucciones Original

8 Operation

8.2 Reading actual values

8.2.1 Gas volume flow regulation

Gas volume flow regulation is used to configure the basic flow. The basic flow is the gas volume flow that
is set by the device for a welding current signal below the shunt control range. Within the shunt
regulation range, the device controls the gas volume flow linearly up to a maximum gas volume flow
(basic flow +7 l/min).

8.2.2 Outlet pressure regulation

The set pressure is the pressure that the system sets between the device output and the solenoid valve in the
wire feeder when welding is not in progress and the solenoid valve in the wire feeder is closed.
EN - 16
This display appears after the diagnosis run is finished with no errors. The basic
flow can be set with the "Setter" or "Service" authorization.
 4.2 Authorization levels/password on page EN-9
To set the basic flow, press the <▲▼> and <◄ ►> arrow buttons.
1
To save the entry, press the <OK> button, or to discard the last change, press
2
the <On/Bypass> button.
► To switch between the actual value displays, press the <◄ ►> arrow buttons.
These actual value displays are for informational purposes only. Values cannot
be changed.
► To switch between the actual value displays, press the <◄ ►> arrow buttons.
These actual value displays are for informational purposes only. Values cannot
be changed.
EWR 2/EWR 2 Net