cecotec BOLERO COOLMARKET TT 90 BLACK Manual De Instrucciones página 42

ENGLISH
ventilation around the device to reduce heat. To do so, there must be sufficient empty
space around the refrigerator.
It is recommended that there is a minimum space of 100 mm from the rear of the
-
refrigerator to the wall, a minimum of 100 mm over the top of the refrigerator, a minimum
of 100 mm from the side of the refrigerator to the wall and a clear space in front to allow
the door to open 135°, as shown in figure 2.
Preparation
1. Clean the refrigerator parts with warm water and a soft cloth or with neutral detergent
and clean water, and then dry them.
2. Place the thermostat knob in position 3 and connect the device to the electric circuit.
3. The refrigerator compressor will light up.
4. Close the door and wait for 30 minutes. If the freezer compartment temperature has
clearly decreased, this indicates that the refrigeration system is working properly.
5. When the refrigerator is in operation for a period of time, the temperature regulator will
automatically adjust the temperature if you do not open the door too often.
6. If you perform the steps above correctly, your refrigerator is ready for use.
Note: The refrigerator electrical parts must only be cleaned with a dry cloth.
Refrigerator door
This refrigerator has been designed with the door hinges on the right-hand side. If you wish to
change the opening direction, follow these instructions.
Warning
Unplug the device from the power supply before reversing the opening direction of the door.
Remove the plug from the socket before starting.
Fig. 3
1. Upper hinge cover
2. Upper hinge fixing screws
3. Upper hinge
4. Adjustable feet
5. Lower hinge
6. Lower hinge fixing screws
7. Adjustable feet
8. Door
1. Remove the upper hinge cover (1) and loosen the upper hinge fixing screws (2). Remove
the upper hinge (3).
2. Place the refrigerator on the floor for better support.
42