Setup - auna Oxford SE Manual De Instrucciones

EN
38

SETUP

Positioning the Retro Turntable
where your Retro Turntable and speakers will be situated. If you place the
Retro Turntable on the same surface and very close to the speakers, the
sound quality can be affected by the airborne movements coming from the
speakers and from any vibrations from the surface on which they have been
placed.
If at all possible, it is recommended that you leave a space of approximately
40cm between each speaker Felt turntable mat Spindle adapter
Getting to know your Retro Turntable You'll be up and running in no time
10 and the Retro Turntable and that the surface on which you have placed
the Retro Turntable and speakers, does not suffer from too much vibration,
which can then be transmitted up into the Retro Turntable. Please make
sure that:
• the Retro Turntable and speakers are on a flat and stable surface, which
does not suffer from too much vibration. If you can, place the speakers
on a different surface to the Retro Turntable.
• it is at least 1 metre away from other electrical appliances to avoid
interference.
• it is within 1.4 metres of a power socket. Please ensure that the mains
power lead and speaker wires are not a trip hazard.
• it is where it will be in range of the connected or 'paired' bluetooth
device (e.g. iPod/ iPhone/iPad/ Android/other phone/Computer), which
is about 10 metres or less (33 feet or less) in line of sight.
• you do not place your Retro Turntable or speakers directly onto antique
or polished surfaces..
Setting up
1. Remove any product packaging materials, including any tape or foam
that has been used to protect the product during transportation.
2. Connect the speakers to the Left and Right speaker sockets on the back
of the Retro Turntable. Please note that the speaker cable with the red
RCA plug should be connected to the red RCA socket and the speaker
cable with the white RCA plug should be connected to the white RCA
socket.
3. Fully extend the wire radio aerial on the back of the Retro Turntable to
receive the best possible FM radio reception and sound quality.
4. Plug the mains power plug into the mains power wall socket and switch
on. Your Retro Turntable will now be in Standby mode.
5. We recommend that you now set the clock.