Publicidad
Idiomas disponibles
Idiomas disponibles
FIG. 1
GASKET
BEZEL
SCREWS
SCREW MOUNT LIGHT SHOWN
1.800.338.7337 / www.soundoffsignal.com
2
WIRE HOLE
WIRE HARNESS
WELL NUTS
SCREW MOUNT INSTALLATION
1. Drill (4) 5/16 holes to mount light. Drill 3/4" wire hole. See
Fig. 2
2. Insert well nuts into the 4 drilled holes. Fully seat to
mounting surface.
3. Align the gasket to the mounting surface.
NOTE: Horizontal and vertical orientations indicated
on gasket for proper seal.
4. Pull the wire harness through the opening and plug into
the back of the light.
5. Place light into gasket, pressing light and gasket against
mount surface.
6. Place bezel over the light.
7. Secure the bezel/light to mount surface using (4) supplied
screws.
NOTE: Tighten until gasket is compressed. DO NOT
overtighten and strip well nuts. DO NOT use power
driver.
DO NOT USE POWER
TOOLS TO TIGHTEN
7X3 SCREW MOUNT PART NUMBERS
EPSSC0JY(x)-R - STT STUD MOUNT/SCREW MOUNT
EPSSC0JY(x)-A - AMBER TURN STUD MOUNT/SCREW MOUNT
7X3 POLYCARB_STT 0122
Publicidad
