Publicidad
Idiomas disponibles
Idiomas disponibles
FIG. 1
GASKET
STUDS
STUD MOUNT LIGHT SHOWN
1.800.338.7337 / www.soundoffsignal.com
4
WIRE HARNESS
DRILL FOR STUD MOUNT
C L
FIG. 2
NOT TO SCALE, FOR REFERENCE ONLY
NUTTS
DRILL FOR WIRE EXIT
STUD MOUNT INSTALLATION
1. Drill (2) 1/4" holes to mount light. Drill 3/4" wire hole. See
Fig. 2
2. Thread studs into back of light.
3. Align gasket to mount surface.
NOTE: Horizontal and vertical orientations indicated
on gasket for proper seal.
4. Plug wire harness into the back of the light.
5. Press light against gasket, against mount surface.
6. Secure the light to mounting surface using (2) supplied
nuts.
NOTE: Tighten until gasket is compressed. DO NOT
over tighten and strip casting threads.
DO NOT USE POWER
TOOLS TO TIGHTEN
NOTE: Bezels are not compatible with Stud Mount
Option
7X3 STUD MOUNT PART NUMBERS
EPSSC0JY(x)-R - Stop/Tail & Turn Light, Stud Mount
EPSSC0JY(x)-A - Turn Light, Stud Mount
7X3 POLYCARB_STT 0122
Publicidad
