Set Up And Installation; Connector Panels - NDS Zerowire G2 Instrucciones

4

Set up and Installation

4.1

Connector Panels

(1)
(2)
(1)
ZEROWIRE® G2 Transmitter
(2)
ZEROWIRE® G2 Receiver
(3)
ON/OFF switch
(4)
Power connector
NOTE!
USB ports are used for installing updates to the Transmitter or Receiver firmware, and not
for use as a general purpose I/O port.
(3) (4) (5) (6)
ZEROWIRE® G2 Transmitter and Receiver connector panels
(5)
(6)
(7)
(8)
(7) (8)
DVI input
DVI output
3G-SDI input
USB ports (for firmware updates)
Set up and Installation
en
| 13