Installation; Mounting Brackets - NDS Zerowire G2 Instrucciones

en
(1)(2)
(1)
Link LED
(2) Link button
(3)
Status LED Transmitter
(4)
Status LED Receiver
The LINK button is used to link a Transmitter to a Receiver.
On the Receiver, the LINK button is also used to activate the Signal Strength bar graph described in section
Signal Strength and OSD Diagnostic Messages [} 26].
4.2

Installation

Mounting Brackets

See ZEROWIRE® G2 Accessory Kits by Display [} 32].
Installation (mounted displays)
NOTE!
This installation requires two people: one to support the display, and one to perform the in-
stallation.
Replace the left-side mounting screws with two of the provided longer length mounting screws. See A in
graphic Installation back view – mounting screws [} 15].
Tighten the provided left-side screws only 2 - 3 turns.
Remove the two right-side screws from the VESA mount. See B in graphic Installation back view – mounting
screws [} 15].
14 | Set up and Installation
(3)
(4)
(1)(2)
Transmitter/Receiver link and status LED