Power Options - NDS Zerowire G2 Instrucciones

en
C D
Installation back view – step bracket and modules
With the back of the ZEROWIRE® G2 Transmitter or Receiver module facing the front of the display, align the
slot on the bottom of the module with the mounting blade, and push the module onto the mounting blade
until the module is firmly seated. See D in graphic Installation back view – step bracket and modules [} 16].
4.3

Power Options

ZEROWIRE® G2 Transmitters and Receivers used with a supported 32" or smaller NDS display can use an op-
tional Y adapter cable for powering the ZEROWIRE® G2 unit. The two types of Y adapter cables are shown be-
low.
Where applicable, the appropriate Y-cable is included in the accessory kit (see ZEROWIRE® G2 Accessory Kits
by Display [} 32] to determine the correct accessory kit for the NDS display being used).
ZEROWIRE® G2 Transmitter and Receiver units can also be powered using the included 24 VDC power supply.
SwitchCraft 'Y' Adapter Cable (35X0096)
16 | Set up and Installation