Avoiding Co-Channel Interference - NDS Zerowire G2 Instrucciones

4.11 Avoiding Co-Channel Interference

If the ZEROWIRE® G2 deployment is a typical one-system per room, there are essentially no restrictions. The
transmitter's Channel Selection feature picks the channel that is least susceptible to interference from the two
available channels based on the result of its scan at power on.
Some of the factors affecting isolation of the ZEROWIRE® G2 channels are listed below.
1. The thickness and material of the room walls.
2. The opening and closing of room doors.
3. The room's ceiling structure and the materials used in its construction.
NOTE!
Cross room operation is not supported.
ZEROWIRE® G2 Transmitter/Receiver pairs must be installed in the same room.
When two Transmitter/Receiver pairs are installed in a given room, each pair must be linked
separately, one pair at a time, linking the second pair after successfully linking the first.
There is no need to turn off the first linked pair before powering or linking the second pair.
Non-line-of-sight
Set up and Installation
en
| 25