Avidsen 100720 Manual De Instrucciones página 37

LED LIGHT
• Flashes continuously: self-testing.
• Flashes once: an intruder has been detected.
• Flashes twice: self-test completed; enters into operating mode.
• Flashing once every 3 seconds: low battery. Replace it. In addition to visual feedback, the
central unit will send an SMS alert about battery status.
Door/window magnetic contact
The door/window contact can be installed on doors, windows and other opening/closing
items. The sensor will send signals to the central unit when the magnet is separated from
the transmitter. The anti-tamper device will trigger the alarm in case of attempts to remove
the door/window contact cover.
LED light
• Flashes once: the door or window is open and the transmitter will send a signal to the
central unit.
• Blinks rapidly: low battery. Replace it. In addition to visual feedback, the central unit will
send an SMS alert about battery status.
RFID Tag
The RFID tag will disarm the central unit immediately. To use it, just pass the tag near the
RFID reader placed on the central unit.
USER MENU - SETTINGS
Date/Hour Setting
• Step 1: Enter into the Main Menu and select Settings.
• Step 2: Choose Date and time to set system's date and time and press Enter.
• Step 3: Return to Settings with ESC.
• Step 4: Choose Date Format to select the format that will appear on the display and confirm
with Enter.
Setting entry/exit delay in line with "Delayed" mode sensors
• Step 1: Enter into the Main Menu and select Settings.
• Step 2: Choose Entry/Exit Delay to set the entry/exit delays and confirm with Enter.
• Step 3: Choose Entry Delay to set the delay time of the sensors in "Delayed" mode, and to
trigger the alarm system.
• Step 4: Select Output Delay to set the delay time and to arm the alarm system.
Setting Auto Arm/Disarm Time
• Step 1: Enter into the Main Menu and select Settings.
• Step 2: Choose Auto Arm/Disarm to set the automatic arm/disarm time and confirm with Enter.
• Step 3: Choose Self-Arm time to set the automatic arm time and press Enter.
• Step 4: Choose Auto Disarm Time to set the automatic arm time and press Enter.
• Step 5: Choose ON or OFF to enable/disable the automatic self-disarm function.
Enable/Disable the control by phone
• Step 1: Enter into the Main Menu and select Settings.
GB
13