Maintenance And Cleaning - GENWEC GW07 Manual De Instalación

Recommended blocking:
If the walls do not have studs on center, then additional blocking is necessary
Contact an architect or building contractor to make sure the blocking is adequate and complies with
building codes.
Operation:
Rotate base downward. Place infant on top of the changing surface. Use restraint system as
described below. After child has been changed, remove restraint system and rotate base back up
against the wall.
Use of restraint system:
Place child so restraint strap is located at abdomen. Rotate top of buckle upward and insert
strap in buckle. Pull strap through buckle until snug against infant. Rotate top of buckle downward to
lock the strap into place. Slide yellow locking tab over top of buckle
strap.

Maintenance and cleaning:

Clean by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use any strong
chemical cleaners or cleaning agents that may be hazardous to children.
Check all hardware and components monthly or as required to ensure hardware is tight and there
are no missing or damaged components. Take unit out of service if any component is missing or
damaged and contact customer service to order replacement parts. Do not substitute parts.
For A.D.A.
Compliance
110mm
(43 1/4")
WARNING
• Child should never be left unattended.
• Always use restraint system to avoid serious injury from fall or sliding out.
• Weight limit 23 kg (50 lb). Avoid adding parcels/packages/ accessories to the unit or the bag
hooks that exceed the weight limit. May cause unit to become unstable or hazardous conditions to
occur.
Instruccions cambiador pañ a les.indd 10
Top
800
on center
(31 1/2")
(Fig. E).
(Fig. F). Reverse steps to loosen
Top of
Buckle
E
Locking
Tab
F
20/5/19 17:08