Werner PN125365 Manual De Utilización página 6

EN
1 1
2 2
3 3
Do not use a stepladder as a means of
crossing over to another surface.
Never stand on the top two treads/rungs
of a stepladder that does not have a
1
2
platform and fittings for hands/knees to
hold on to.
Do not climb this side of a stepladder.
5
Scope of delivery
1 x Multi-purpose ladder
1 x Instruction manual
6
Setup and use
Mode of operation on page 2 . For commercial use, it
is recommended to perform an inspection and record
it on an inspection label before using the ladder for the
first time (see "Periodic inspections" on page 7 ).
WARNING
Always check that the hinges are in order and no
damage before using the ladder.
See page 2 .
7
Maintenance and servicing
To ensure safety when using the ladder, we
recommend using only original spare parts. Using
spare parts from other manufacturers that do not meet
the required specifications may void the warranty.
Care and maintenance of the ladder are meant
to ensure its proper functioning. The ladder must
be regularly inspected for signs of damage. It is
necessary to ensure that moving parts are functioning
properly.
6
Never stand on the top three
rungs of a single ladder.
Always check that the
locking mechanism on the
hinges are in order and fully
locked before using the
ladder.
Repair work on the ladder has to be carried out by
a competent person and in accordance with the
manufacturer's instructions.
Cleaning
The ladder should be cleaned immediately after use if it
is visibly soiled. This applies especially to all its moving
parts. The product can be cleaned using water and a
small amount of conventional cleaning agent. Do not
allow cleaning agents to seep into the soil.
• Dispose of used cleaning solutions in accordance
with the applicable environmental regulations.
Lubricating moving parts
• Lubricate all moving parts with conventional
lubricating oil. Select a thin-bodied oil when using the
product in winter.
• Dispose of oil-soaked cleaning rags according to the
relevant environmental regulations.
WARNING
Slippery surfaces are a source of fall hazard!
Lubricating oil and liquids on standing surfaces can
cause personnel to fall and injure themselves.
• Wipe off excess oil.
• Clean off any soiling (e.g. wet paint, snow).
7.1 Commercial use
For commercial use, it is necessary to have the ladder
periodically inspected by a competent person to
ensure it is in good working order (visual inspection
and functional check).
It is crucial to define the type, scope and schedule
of the necessary inspections. The intervals between
inspections depend on the operating conditions,
especially the frequency of use, the stress the
product is subject to during use, and the frequency
and severity of previously found defects. The user
must ensure that defective ladders are removed
from use and stored in such a way that makes
it impossible for them to be used until they are
properly repaired or disposed of. The complete
inspection sheet can be downloaded from the
manufacturer's website.