Electrical Safety; Initial Operation; Battery Pack - Metabo TPF 18 LTX 2200 Manual Original

Do not let the pump run for more than 10 minutes
against a closed pressure side (e.g. closed
regulating valve).
Do not use the product while you are tired or under
the influence of drugs, alcohol or medication. A
moment of inattention during the operation may
result in serious personal injury.
Do not open the pump more than how it was
delivered (only exception: the filter and the stand).
4.2

Electrical safety

DANGER! Cardiac arrest.
This product generates an electro-magnetic field
during operation. Under certain conditions, this field
can affect the functioning of active or passive
medical implants. In order to eliminate the risk of
situations that could result in serious or fatal injuries,
persons with a medical implant should consult their
physician and the implant manufacturer before
using this product.
Regularly check the connection line.
Always carry out a visual inspection before using
the pump.
A damaged pump must not be used. In the event of
damage, it is mandatory to have the pump checked
by Metabo.
Protect the battery pack contacts from moisture.
4.3 Safety instructions for battery packs:
Remove the battery pack from the machine when
not in use.
Do not immerse the battery pack unit in the
water.
Protect battery packs from water and
moisture!
Do not expose battery packs to fire!
Do not use faulty or deformed battery packs!
Do not open battery packs!
Do not touch or short circuit battery pack contacts!
A slightly acidic, flammable fluid may leak
from defective Li-Ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks out
and comes into contact with your eyes, wash them
with clean water and seek medical attention
immediately!
Remove the battery pack from the machine before
making any adjustments, changing tools,
maintaining or cleaning.
Make sure that the tool is switched off before fitting
the battery pack.
Hold the machine when removing and inserting the
battery pack so that the on/off switch cannot be
unintentionally pressed.
If the machine is defective, remove the battery pack
from the machine.
Transport of Li-Ion battery packs:
The shipping of Li-Ion battery packs is subject to
laws related to the carriage of hazardous goods (UN
3480 and UN 3481). Inform yourself of the currently
valid specifications when shipping Li-Ion battery
packs. If necessary, consult your freight forwarder.
Certified packaging is available from Metabo.
Only send the battery pack if the housing is intact
and no fluid is leaking. Remove the battery pack
from the machine for sending. Prevent the contacts
from short-circuiting (e.g. by protecting them with
adhesive tape).
WARNING - General hazards
Read the operating instructions.
5. Overview
See page 2.
1 Machine stand
2 Ring
3 Cable winder
4 Pump casing
5 Cables
6 Pump connection
7 Battery pack box
8 Control panel
9 LED fault display
10 ON/OFF button
11 Power level selection
12 Timer function button
13 Status LED battery pack

14 Battery pack *

15 Locking of the protective cover
16 Protective cover
17 Capacity and signal display*
18 Button of capacity display*
19 Hose
20 Hose guide*
21 Quick couplings
22 Regulating/shut-off valve
23 Recesses for wall mount
24 Underside battery box
25 Fastening hooks
26 Mounting hook
27 Multi-adapter
28 Tap connector
29 Filter
*equipment-specific

6. Initial Operation

6.1 Battery pack
Charge the battery pack before use.
Recharge the battery pack if performance
diminishes.
ENGLISH en
11