Troubleshooting Guide - Good Earth Lighting SE1249-BP2-02LF7-G Manual De Instrucciones

DANGER!
PROBLEM
Security light
1. Light switch is o .
does not come
2. Fuse is blown or circuit breaker has tripped.
on.
3. Fixture not properly wired to junction box.
4. Light is detected by sensor.
5. Motion sensor is pointed in the wrong
6. Air temperature is about the same as a
Light continuously 1. Light sensor is triggered by reflected light
cycles ON and OFF
(Strobe e ect).
2. Heat is being reflected from other sources
Light turns on 1. Light may be installed in shadows/dark area.
during daylight
hours.
2. The MINUTES control knob is set to
1. Sensor may be triggered by a small
Light comes on for
no apparent reason.
2. Hot air (dryer vent, car exhaust, etc.) may
Light stays on
1. Motion sensor may be picking up a
continuously at
night.
2. Interference generated from transformers,
1. The MINUTES control knob is set to
Light flashes on
for 20 seconds at
a time, day or
night.
Light head slips 1. Star knobs are loose.
down.
Light output is to 1. Brightness button was pressed to many
bright or to low.
Light output is too 1. Press white light selection button to
warm,neutral,cool.
REPLACEMENT PARTS LIST: Hardware Kit: ZH-SE1249-F01-BP2
Need Help?
Good Earth Lighting
Good Earth Lighting
10

Troubleshooting Guide

Before doing any work on the fixture, shut o power supply
at the circuit breaker panel to avoid electrical shock.
POSSIBLE CAUSE
direction.
person's body temperature and the PIR
sensor cannot "see" the person.
from the security light itself.
and may be triggering sensor on and o .
MOTION TEST.
animal or passing car.
be triggering the sensor.
continuous flow of warm air from an air
vent, dryer vent, or heat reflecting o
a surface.
fluorescent light fixtures, or electric motors
are connected to the same circuit.
MOTION TEST.
times.
desired light temp.
Please visit our website at: https://goodearthlighting.com/contact-us or call the Customer Care Center
1-800-291-8838, 8:30 a.m.-5 p.m., CST, Monday-Friday.
1400 East Business Center Drive, Ste. 108 Mount Prospect, IL 60056
®
is a registered trademark of Good Earth Lighting, Inc. © 2022 Good Earth Lighting, Inc. REV08.22
®
CORRECTIVE ACTION
1. Turn light switch on.
2. Replace fuse. Turn the circuit breaker back on.
3. Discontinue use, call an electrician.
4. Recheck at night.
5. Readjust motion sensor.
6. Decrease the DISTANCE control setting.
1. Change the position of the light head, aim light away
from the reflecting surfaces.
2. Decrease the DISTANCE control setting.
1. Light is operating as it was designed. Use manual
override if necessary. Or set to "switch control."
2. Set the MINUTES control knob somewhere between 1
and 10.
1. Decrease the DISTANCE control setting as necessary.
2. Increase the DISTANCE control setting as necessary.
1. Reposition the motion sensor.
2. Install the light on a circuit without transformers,
fluorescent light fixtures or electric motors
connected to the circuit.
1. Set the MINUTES control knob somewhere between
1 and 10.
1. Reposition light head and tighten star knobs.
1. Press the low/high beam control button once to
change the high/low beam.
1. Press white light selection button to change to a
warmer, more neutral or cooler white light
selection.
Printed in Vietnam