Mounting And Removing X-Lock Accessories - Bosch GWX18V-8 Instrucciones De Funcionamiento Y Seguridad

160992A61E 08-21 GWX18V8.qxp_GWX 9/1/21 8:29 AM Page 16
Mounting and Removing
X-Lock Accessories
accessories. Incompatible accessory
mounting features may affect clamping of
accessory and may result in personal injury
and/or property damage.
the accessory X-Lock mounting hub
surface is not above the top of the
clamping height gage. Accessories that are
above the clamping height gage may not be
fixed properly and separate from the the
tool causing personal injury and/or property
damage.
accessory clamping flange before use. Do
not use the tool or accessory if the
accessory mount or accessory is damaged
or deformed. Accessories that are not
clamped properly may cause personal injury
and/or property damage.
material on clamping surfaces and remove
before use. Unwanted material can cause
incomplete clamping and may cause
personal injury and/or property damage.
accessory is moving. Make sure that the
accessory has come to a complete stop
before removing the accessory. Ejecting
accessory while still spinning could cause
personal injury and/or property damage.
Verify that the accessory and the X-Lock
Accessory Mount are not deformed and are
free from dirt. If necessary, clean the area
around the two X-Lock Clamping Tabs.
Verify that both X-Lock Clamping Tabs are
open (see Fig. 7) before fitting the X-Lock
accessory.
MOUNTING ACCESSORY TO THE TOOL
1. Place the accessory on the X-Lock
Accessory Mount, by aligning the shape
of the Accessory X-Lock Mounting Hub
with the X-Lock Accessory Mount on the
grinder (Fig. 7).
Assembly
Only use Bosch or Bosch
licensed X-LOCK
Confirm proper clamping
by ensuring that top of
Always inspect
accessory mount and
Check for presence or
buildup of foreign
Never actuate X-Lock
Release Lever while
Fig. 7
Accessory
X-Lock
Mounting Hub
X-Lock
Accessory
Mount
Fig. 8
2. Push the accessory into the X-Lock
Accessory Mount. The accessory audibly
clicks as the Clamping Tabs lock into
place (Fig. 8).
3. Check that the edge of the Accessory X-
Lock Mounting Hub is correctly engaged
in the slots of the X-Lock Clamping Tabs
(Fig. 9). If the top surface of the
Accessory X-Lock Mounting Hub is higher
than the "V" shaped Clamping Height
Gage (located on each side of the X-Lock
Accessory Mount), the X-Lock accessory
must not be used until this condition is
eliminated by cleaning the X-Lock
Accessory Mount or replacing the
accessory.
-16-
Click!